If I adjust my BL parameters to be something high like 40 tenths and jog at 1x with the hand wheel I get this:įirst click BIG jump on the indicator due to high BL parameter, then subsequent clicks motion slows down, dial doesn't read any movement for some mpg steps and if I continue the dial ends up far short of my expected distance based on the DRO/MPG. When I move from 0-4 thou on a tenths indicator one direction only I'm ~.009 off(!) When I mpg from 0-4 thou and then back again on a tenths indicator the dro is ~.0006 off (back at original dial location)
I had some diameters come out a little off so I checked my BL parameters vs a dial and saw interesting results. Hey guys, I have a curious issue with the X axis on my QT15. I will read voltage coming from the female/machine side of the plug and post up. Pressing any of the 4 tool buttons would break this continuity, so I figured that was my smoking gun (it never is when you're that sure). I bypassed and connected the wires going to the LED and the tool eye showed continuity across the plug pins. When I opened the top of the unit to expose the LED, I did not get continuity across the LED, nor did it light with external DC power. The LED never has lit, I pulled it today and did not get continuity across the two pins on the plug (like one of the switches was open). It just occurred to me as I'm writing this that I may not be getting voltage to the tool eye. I posted my parameters for reference to the question but also in case someone else needs them on the forum, I'd have loved to come across these with just a search. When I enter 0, I get a blue "insufficient data" error in the corner of the screen. I can set them to any other number but 0, actually. Is it possible that one of the parameters pertaining to the tool eye is incorrect?Īside from the tool setter business, I'm also seeing that parameters M28-M31 cannot be set to 0 (as the parameter sheet shows they should be). I now have a clean set of parameters in the machine that came direct from Japan, with my serial number on the sheet (so I'm reasonably confident in them). I replaced the battery and at that time, the tool setter beeped when it would extend.
it also does not enter a value when you touch off on it.Ī little background on the machine, I bought it with a dead battery and dubious parameters. When the tool setter extends on the tool measure command, it does not beep. I've got a 1986 QT-10N, 20 HP, 12 position turret with the tailbody (universal).
0 kommentar(er)
